Vollrath F144 User Manual download pdf (Page 21)

Owner’s Manual #513677 15 F144I2, SF144I2 and SF121I2 Model Machines

SECTION 5

TROUBLESHOOTING

5.1 ERROR CODES

When the machine experiences a problem, one of the

following error codes will be displayed on the control

panel. Each error code directs you to the system location

of the malfunction.

ERROR CODE MALFUNCTION

2 High Torque

3 Run Time

4 Clean

5 Freezing Cylinder Sensor

6 Hopper Sensor (single hopper machines)

7 Drive Motor

8 Cab Sensor

9 High Pressure Cutout

10 Auxiliary Sensor

11 Prime (cab units only)

12 Left Hopper Sensor

13 Right Hopper Sensor

21 Spigot Open Time

To return the machine to normal operation, any error

causing condition must be corrected and the power to

the affected freezing cylinder must be cycled. Turn the

power to the freezing cylinder off then back on using the

On/Off button of the affected freezing cylinder.

5.2 TROUBLESHOOTING

Error Code 2 - High Torque

If the control panel displays a High Torque Error

(E2), the controller has sensed that the drive motor

is running at a high load for 10 or more seconds.

This may be due to the product consistency

adjustment being set too high. Press the On/Off

button for the cylinder to turn it off, wait until the

product in the freezing cylinder thaws and then

turn the cylinder back on. If the error persists,

contact your Authorized Stoelting Distributor for

further assistance.

Error Code 3 - Run Time

The Run Time Error (E3) occurs when the

compressor runs continuously for an extended

period. This error is generally caused by very

low mix levels in the hopper or from product

breakdown. Another common cause results from

a restriction preventing mix from entering the

freezing cylinder. Check the mix in the hopper.

If the level mix is low, add mix. If there is a

possibility that the mix has broken down, clean

and sanitize the machine and replace the mix

with fresh product.

Ice crystals in the hopper can clog the mix inlet

system and prevent mix from entering the freezing

cylinder. Thoroughly thaw mix per manufacturer’s

recommendations. To check for ice crystals, pour

a small amount of product from the mix container

through a clean and sanitized sieve or strainer.

If ice crystals are in the mix, check temperature

of the walk-in cooler where the mix is stored.

In air cooled machines, the Run Time Error

may indicate that airﬂ ow within the machine

has reduced or stopped. Check the sides of the

machine for anything that would restrict airﬂ ow.

If the error persists after attempting to clear it,

contact your Authorized Stoelting Distributor for

further assistance.

Error Code 4 - Clean

If the machine is left in the Clean Mode for more

than 20 minutes, the control panel will display a

Clean Error (E4). This condition does not reﬂ ect a

problem with the machine itself. The Clean Error

has been programmed into the controller as a

safeguard to protect the machine from potential

damage caused by the machine being accidentally

left in "Clean Mode". To clear the Clean Error,

press the On/Off button for the cylinder to turn if

off then back on.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 27 28 29

Comments to this Manuals

No comments

Vollrath F144 User Manual Page 21

Comments to this Manuals

Related products and manuals for Kitchen Vollrath F144